Water backing up in the bottom of the wheel housing will cause excessive splashing and an overflow of water below the work table. Avoid crimping the hose which will restrict the flow of water. Secure the Model Trimmer (using screws or bolts) to its supporting surface and adjust the drain hose so that the discharge end is directed downward into the sink. This will securely hold the tubing to the fitting and prevent leaking. Be certain that the small sleeve located in the fitting is slipped over the tubing when the brass nut is tightened. At the same time attach the water supply tubing to the compression type fitting, also located at the bottom of the rear wheel housing. Install the Model Trimmer on a bench, shelf, or platform that is level and close enough for the drain hose to reach from the Model Trimmer to the sink.Īttach the drain hose by slipping one end over the drain pipe located on the bottom of the rear wheel housing. Click to expand.Hi MEJ here are the instructions I got when I had purchased the trimmer.
0 kommentar(er)
